Jump to content

Help with center seam


Doug Rice
 Share

Recommended Posts

Hi All,

I am making a new violin. When I hold the top against a strong light, I can see a very faint clear stripe at the center seam. The seam is not open, but I am worried about it. It may have happened when I took the top off (another story.)

I tried heating it up with a heat gun, rubbing in some hot glue, and using those curved clamps that arch across the bouts. I thought it was tight when I clamped it, but now it looks like it did before.

I am thinking of trying either:

1. The heat gun again (or an alcohol lamp) and waiting until I see the glue bubble slightly, then using the arch clamps.

2. Heat plus thin glue or *very* hot water, plus clamping.

3. Something from one of you people who know a heck of a lot more than I do.

4. Last resort: make a new top or stop worrying about it.

Thanks for you help

Doug

Link to comment
Share on other sites

Doug,

Glue a small block on each side if the center seam gap near the middle of the gap on the under side of the plate and squeeze them together with a clamp until the gap closes.

Then wam the glue joint with a alcohol lamp or light bulb until the glue softens. Snug the clamps a little more and clean off any glue that comes out of the joint with a damp sponge and leave until dry.

If the edges of the gap don't line up perfectly flush, the sides of the blocks that that face each other can be tapered either towards each other or away from each other to eliminate a "curl" up or down, and the blocks can be gently tapped to raise one side od the plate or the other. Small brass hammer works great.

-----Barry

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.


×
×
  • Create New...