Search the Community
Showing results for tags 'hide'.
Found 1 result
Hi people :-) I'm repairing a fairly old violin that I found in a local antique store. It's not very special, but it seems well built and I expect it to have a nice tone. Besides, I'm still learning. I've repaired a couple of violins before, but I don't want to work on anything too good yet. The top had two cracks. I glued the first one and it went quite well. The other one, however was more difficult. The wood had moved over time, so the crack was wide open and required quite bit of clamping to stay together in the right position. I set it to cure overnight, but one of the clamps must have gotten loose, because the crack is now open in the middle and perfectly closed in the sides. My question is: how do I remove the now hard hide glue in the crack that's preventing it from closing rather than holding it together? Will it be sufficient to heat up the area with a heat gun and reclamp it? would that daamage the wwood or the finish? I've tried scraping carefully with a knife, but it's not very effective, and I can't reach the "corners" where the crack goes from open to closed. I was also considering a damp brush, but I don't know if softening/removing the glue would take so much water I'd ruin the wood... Is there any good way to do this? And yes, I will be more careful next time with my clamping :-/