Search the Community
Showing results for tags 'choice of tools'.
Found 5 results
tools (Another) Scroll Gouge Thread
David Rosales posted a topic in The PegboxI recently ordered a set of Karlsson scroll gouges. At the advice of a fellow Maestronet member, I took the Karlsson sweep table and laid it over a scroll template to see which ones would be the most useful for that particular template. I thought the following gouges fit the bill: 5-10mm 7-10mm 9-12mm 19-20mm I already submitted an order. But, after looking at my list, I realized that the two smallest gouges I ordered have the same radius, just a different length. Should I change the order before they start production and switch the 5-10mm for the 4-6mm instead? Would that make the set more useful? Also, if anyone else has been looking for it, here's the Karlsson set that @JacksonMaberry ordered a few years ago:
choice of tools Woodworking Files
David Rosales posted a topic in The PegboxThis is one tool that really confuses me (along with bow saws). But I have a flat and a half round file I got at a used tools store. I think they’re junk and don’t work very well. Looking at the different files out there and there seem to be different labeling systems for coarseness and pattern and it’s a bit confusing to me. Will someone recommend a specific product you like? I’m looking for a single cut flat file and a cross cut file. Derber recommends 0-cut for both. While we’re on the topic, rasps. Get it or skip it?
wood preparation Planing the Center Joint
David Rosales posted a topic in The Pegbox(Preface: I have done a search for this topic but didn’t find quite what I was looking for) I’m studying the Derber book and I’m on the chapter regarding the center joint. He advocates for a rubbed spring joint for the center joint (no clamping) that is created by using a wooden jointer plane clamped upside down on the work surface upon which the billet (is that the right word?) is dragged across. The Johnson/Courtnall book offers a different method where the wood is clamped and the edge planed by dragging the plane across the wood. This appears to be the most common method of planing boards used by furniture or cabinet makers I’ve seen in YouTube videos. Most of the ones I’ve seen on those videos use a jack plane instead of a jointer plane. My question is, how are you guys planing your joints? Are there other methods than the two I’ve mentioned? I’d rather not make a wooden jointer plane from scratch if I can avoid it. Am I setting myself up for failure if I follow the Johnson/Courtnall method using a jack plane instead?
Favorite Tools or Equipment
David Rosales posted a topic in The PegboxI know there have a been a few of these threads in the past but the latest one I could find is over a decade old. What are your top 3 tools or pieces of equipment that you absolutely couldn’t live without and why?
tools Taytools Thickness Gauge
David Rosales posted a topic in The Pegboxhttps://www.amazon.com/Taytools-Thickness-Measuring-Resolution-Accuracy/dp/B084YR9N9V I found this dial thickness gauge on Amazon. It's supposedly made by Taylor Toolworks but I can't find the product on their website. It's about half the price of all the others I've seen, granted it has a maximum range of 22 mm. Has anyone used it or have any more information on it? It has a flat anvil tip. Is that a dealbreaker?